Just wondering if anyone in the forum has experienced a P018C Fuel Pressure Sensor B Low Circuit DTC
The car runs fine, but will log this code right away, then after a day or two of driving, it'll throw the CEL MIL.
Along with the P018C Fuel Pressure Sensor B Low Circuit it'll usually have a P1450 "unable to bleed up fuel tank vacuum" as well. I've got a new purge valve ordered and was wondering if replacing the fuel pressure sensor might be in order as well.
A little back story on this, not sure if it makes any difference or not. I bought the car used in March, its always run excellent, however about a month ago there intercooler charge hose to the throttle body developed a hole and subsequent loss of boost. Apparently someone may have nicked or cut the hose while changing oil filter, (looked like it was right in that area). The hose was replaced, boost restored, but then started throwing the two codes mentioned and check engine light. The weird part is, that it never had a check engine light before the hose replacement and like I said, always ran fine and still does.
Any ideas would be helpful, thanks.
Thx!
The car runs fine, but will log this code right away, then after a day or two of driving, it'll throw the CEL MIL.
Along with the P018C Fuel Pressure Sensor B Low Circuit it'll usually have a P1450 "unable to bleed up fuel tank vacuum" as well. I've got a new purge valve ordered and was wondering if replacing the fuel pressure sensor might be in order as well.
A little back story on this, not sure if it makes any difference or not. I bought the car used in March, its always run excellent, however about a month ago there intercooler charge hose to the throttle body developed a hole and subsequent loss of boost. Apparently someone may have nicked or cut the hose while changing oil filter, (looked like it was right in that area). The hose was replaced, boost restored, but then started throwing the two codes mentioned and check engine light. The weird part is, that it never had a check engine light before the hose replacement and like I said, always ran fine and still does.
Any ideas would be helpful, thanks.
Thx!
