Ford Focus ST Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter · #1 ·
I just bought my Race Red 2016 Focus ST 2 weeks ago..

I believe in splurging on high quality parts, because nobody wants to tackle the same project twice. I'm not an experienced tuner by any means but I'm down to learn everything I can to ensure everything is done properly..

I hope to build an ST worth registering at the indoor section of the OC Car Show. #goals
 

Attachments

·
Registered
Joined
·
18 Posts
Welcome! Where about in Virginia? I lived in Richmond for a bit and Tidewater for a bit until the wife capitalized on my layoff and forced a move to Pittsburgh.
 

·
Registered
Joined
·
9,129 Posts
Congrats on the ride!
If you're going to bore over 88 mm I suggest you re-sleeve the block.
Purchase a LSD, oil catch can, and maybe some syncro for the tranny. Careful of the ECU, its fragile.
Watch out for that rear main seal its a *****.
 

·
Registered
Joined
·
34 Posts
Discussion Starter · #4 ·
I live in Suffolk, VA. I will add that the ST community is pretty diverse and seems full of good people.
 

·
Registered
Joined
·
34 Posts
Discussion Starter · #5 ·
Congrats on the ride!
If you're going to bore over 88 mm I suggest you re-sleeve the block.
Purchase a LSD, oil catch can, and maybe some syncro for the tranny. Careful of the ECU, its fragile.
Watch out for that rear main seal its a *****.
I'm starting with simple bolt ons, I have much to learn before I consider pulling the motor apart...
 
1 - 5 of 5 Posts
Top