T-Bolt Clamp size for FMIC

8549 Views 6 Replies 3 Participants Last post by Kdub085, Dec 18, 2016

Kdub085

Discussion Starter · Dec 17, 2016

Pretty sure I have a boost leak, I'm gonna take apart the front bumper and change out the original worm clamps, I couldn't get the t-bolt clamps on originally when I installed my fmic last year.

I tied to use a 67-72mm which I thought was 2.5" (maybe they were more like 2.25") but it was too tight, so I gave up and re-used the stock clamps... my mistake!

What size t-bolt clamps should I use? 2.5" or 2.75"?

HPS (SSTC-70-78) 70mm - 78mm Stainless Steel T-Bolt Clamp for 2-1/2" Hose https://www.amazon.com/dp/B0058W7WK6/ref=cm_sw_r_cp_api_vYkvybHB6TGDX

HPS (SSTC-76-84) 76mm - 84mm Stainless Steel T-Bolt Clamp for 2-3/4" Hose https://www.amazon.com/dp/B0058W7X0A/ref=cm_sw_r_cp_api_UYkvybQD3H90C

Sent from my iPhone using Tapatalk

Save

1 - 2 of 7 Posts

ChrisL

· #4 · Dec 18, 2016

Agree with Moosehead.

I used these, 2.75" SSTC-70-78:
https://www.amazon.com/gp/product/B0058W7WK6/ref=oh_aui_search_detailpage?ie=UTF8&psc=1

Save

ChrisL

· #6 · Dec 18, 2016 (Edited)

Kdub085 said:
That link is for the 2.50's

Sent from my iPhone using Tapatalk

HPS Stainless Steel T-Bolt Clamp 70 millimeter-78 millimeter (2.76 inch-3.07 inch) for hose with 2-1/2 inch (63 millimeter) inside diameter. I was basing it off of the outer diameter after researching the ID requirement..

Works well.

Save

Reactions: 1

1 - 2 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month