Ford Focus ST Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
OK, installed the JBR short shift arm and heavy knob. While finishing up the connections after the arm was installed, I am having lots of trouble getting the air tubes back into the holes they were in.

Anyone know of any tricks I can try? Am I missing something obvious? I have tried using a screwdriver to shimmy them in, but no dice. Do I need to heat the rubber sockets first? Grasping at straws here.

Any help would be appreciated.
 

·
Registered
Joined
·
162 Posts
A little silicone spray usually works.
 
1 - 3 of 3 Posts
Top