[CoolTech]

If a current gen ST owner could kindly provide me with the dimension as seen in the photo below, it would be greatly appreciated!!

 

[ddfred]

As seen in the photo, without measuring, I'd say about 3/4 inch.

 

[CoolTech]

As seen in the photo, without measuring, I'd say about 3/4 inch.

Everyone is a comedian!!

 

[brian60]

As seen in the photo, without measuring, I'd say about 3/4 inch.

You might just be my favorite moderator on this forum. (Sorry to other moderators lol)

 

[UnfocusedST]

I'm a bit confused on what the OP is asking.

Sent from another garage.

 

[CoolTech]

I'm a bit confused on what the OP is asking.

Sorry that I was not more clear. In the referenced picture above, I'm trying to determine the ctr to ctr distance between those two holes in the chassis - each of them having a rubber plug in them from the factory. The reason is that we make some Focus RS - specific parts, one of them being some solid-billet bolt-on Jack Rails. We had an ST-owner inquire to see if our Jack Rails would fit onto his ST - and frankly we do not know the answer. I suspect that they will work as the underside of both cars looks the same from these pictures. However, if someone could provide us with this dimension, then we would know for certain.

 

[UnfocusedST]

If I get the chance I'll grab some measurements. My car is currently on jack stands anyways.

 

[UnfocusedST]

So for those two center to center looks to be about 9 3/4 inches.

Sent from another garage.

 

[CoolTech]

Perfect. Thanks very much. Same as the RS, FYI. Our Jack Rails will fit.

 

[UnfocusedST]

Do they require drilling?

Sent from another garage.

 

[ddfred]

Everyone is a comedian!!

Sorry???

 

[CoolTech]

Sorry???

LOL! Even as the "victim" I still couldn't help but laugh! Life is good!