[tayrayne]

I just bought some h&r lowering springs for my 2016 focus st and trying to put them on myself but I can't figure out how to get this ***** out every video says "just put a wrench back there and it comes right off" there's no way for me to get a wrench back on the end link a 17 fits but it's not tight enough anyone have any ideas??

Sent from my iPhone using Tapatalk

 

[tpiechow]

Yeah I just installed the same coils on my 2016.

Everyone told me that there is a place back there for a wrench, I could not find it.

I was able to get it off my putting a set of channel locks on the back side and using a 15MM socket on the front. (This is the easiest/fastest way)

You could also use a 15MM wrench on the front, off to the side and then use an allen head socket on the bolt. Just make sure you turn the allen high clockwise when holding the nut. (this is difficult and time consuming)

 

[Allen_rubin]

Need an open ended socket, pass through socket wrench.... then get a Allen wrench to go through the scented and hold it while loosening the nut. Not hard at all... just need the right tools.

 

[tayrayne]

Thanks for the help finally got them figured out


Sent from my iPhone using Tapatalk