Ford Focus ST Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
593 Posts
Discussion Starter · #1 ·
Hi all, I have an issue with the below piece circled staying attached to the front...
Focus ST engine Bay.PNG

I honestly hate this piece anyways, I think it just fits very poorly.

Anyways, is there some kind of solution anyone has to keep the rectangular rubber piece attached to the front of the engine bay?

EDIT: I can totally take a better picture of my own car to show exactly what is happening, but I'm in Mexico so that will have to wait.
 

·
Registered
Joined
·
59 Posts
I have a cpe intake that reuses that piece and out would never stay in place. So eventually i got tired of messing with it and yanked it off. My intake temp may be higher and air flow off but it works fine without it.

Sent from my SM-G935T using Tapatalk
 

·
Premium Member
Joined
·
13,881 Posts
I have a cpe intake that reuses that piece and out would never stay in place. So eventually i got tired of messing with it and yanked it off. My intake temp may be higher and air flow off but it works fine without it.

Sent from my SM-G935T using Tapatalk
Cpe has a fix for that. It's an plate that clamps it in. There was a batch of intakes that had the issue.

Sent from another galaxy.
 
1 - 7 of 7 Posts
Top