[SIstomper]

@djfourmoney had a little nitrous issue so the motor ended up at my house for a rebuild. It hurt piston four. Motor will be forged 2.0 with stock cams, valve springs, arp studs, balance shaft delete, keyed crank and race bearings. Here's the tear down

 

[djfourmoney]

Yeah I didn't discuss this out in the open yet, I will at some point.

Nitrous is staying on the car, let the fun begin!

 

[Stealth]

 

[SIstomper]

Carnage pics. Block is dust, crank is even bent. Both these rods are bent and the piston and cylinder damage is obvious lol.





Metal everywhere even in the oil pump. We are going to plan B now.

 

[SIstomper]

On another note Ford got rid of the oil control baffles that were in the earlier engine pans. I dont know what year Ford took them out as this car is a 2017

 

[djfourmoney]

2016...

 

[djfourmoney]

I'm going to say that is pretty much over 400 lbs of torque to do that, at 3,000 rpm....

 

[kewing]

:shocked:

WOW!! That's crazy! Good luck with the build! Time to come back stronger than before! Can't wait to follow this.

 

[SIstomper]

2016...

Sorry thought it was a 17. They must have got rid of them in 15 with the facelift

 

[BlackT5]

If you're going to blow it up, do it properly!

 

[SIstomper]

If you're going to blow it up, do it properly!

No sh!t

 

[BlackT5]

Wow!

 

[NJFocusST]

no sh!t

View attachment 270193

holy ****.

 

[DDT1972]

Plan B?

 

[willfromfreeport]

No sh!t

View attachment 270193

You blew the welds on the manifold!

Seriously though, did the nitrous cause this? It's the first intake manifold I've seen popped.

 

[BlackT5]

Yeah, when are you going to tell us about the nitrous back fire that caused this. 400 ft/lbs of torque down low didn't do this.

 

[Stealth]

oh damn he said you a *****... *****

 

[SIstomper]

Plan B?

Yeah hes dropping off a junkyard engine

 

[Stealth]

Plan B?

 

[SIstomper]

Now my side hurts fuc&er lol. Here's the actual plan B. 2013 motor from a Escape, junkyard find $300