Ford Focus ST Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
198 Posts
Discussion Starter · #1 ·
Hey everyone,

I just wanted to put it out there, for some advice, and maybe some suggestions for people who have worked under the 2013 ST a little bit more than I. I have some decent TIG welding skills, but no TIG...i might try to rent one, but then i need a place to actually do the welding once Ive gotten all the pipe.

Here is what I want to do:

3" inlet on a single straight through muffler (probably magnaflow) with 2 1.25" outlets, or a single 3" IN/OUT to a Y piece. I want to exit either through a cutout in the side skirt right in front of the rear tires...looks like there is space to get a pipe out on both side with a little bendypoo here and there.

Im in the King of Prussia PA/ Exton area if anyone wants to help out, or knows a shop that can weld up plans it would be much appreciated.
 

·
Registered
Joined
·
176 Posts
I’ve been in aerospace for almost a decade welding/fabricating and doing development work. Also been building stuff for race cars for a long time as well. I made a side exit for my SRT4 it wasn’t all that bad
 
1 - 2 of 2 Posts
Top