Ford Focus ST Forum banner
1 - 2 of 2 Posts

· Registered
27 Posts
Discussion Starter · #1 ·
As in the description, I had a gtx 2867, fmic, dp, exhaust, tune, I decided to put the car back to stock minus the exhaust. I threw the original tune back on via my access port and it says engine fault service now and the code read is p1023. Any ideas? I clear the code and it comes right back when I turn the car on not even start it. I changed the map back to see if it would do anything, and still pops up.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.