Carbon Fiber Vinyl Wrap

6034 Views 17 Replies 6 Participants Last post by Unfitproduct, Jan 10, 2017

xxStEf10xx

Discussion Starter · Jan 10, 2017

Hi everybody. First forum post! I wrapped the plastic trim piece around the shifter in carbon fiber vinyl. I was just curious to see if I would like it as it was my first time wrapping anything. Have to redo it I screwed up on one end but not too noticeable for now! Let me know what you think!

Car Vehicle Gear shift Mid-size car Auto part

Sent from my SM-G930W8 using Tapatalk

See less See more

Save

Reactions: 1

1 - 3 of 18 Posts

mike-st2

· #2 · Jan 10, 2017

I think that looks amazing!?? I've done exactly the same to mine

Sent from my FRD-L04 using Tapatalk

Save

mike-st2

· #4 · Jan 10, 2017

xxStEf10xx said:
Thanks glad someone else likes it too! I saw you plasti dipped the shiny "metal" pieces red. Were they easy to take off?

Sent from my SM-G930W8 using Tapatalk

It took a bit of time to figure out how they come apart but it wasn't terrible. If u pop the plastic panel off the end of the dash there's a screw underneath that holds the vent in place. Take that out and then there's some clips that hold it in also. You may have to get a small screwdriver or trim tool an pry up on the outside of the vent to see the clips. But be careful with them cause there completely plastic.

Sent from my FRD-L04 using Tapatalk

Save

mike-st2

· #5 · Jan 10, 2017

And here's a pic of my wrap. Now I want the carbon fiber shift knob!

Sent from my FRD-L04 using Tapatalk

See less See more

Save

1 - 3 of 18 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month