Ford Focus ST Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
2,754 Posts
This should be a sticky.... very informative if you don't want to rummage through the internet or users manual book
 
  • Like
Reactions: jalapeno

·
Registered
Joined
·
1,656 Posts
:whs: Awesome post idea man, thanks for this! I am sure it will come in handy.

Edit: And I was saying it should be stickied as you were sticking it......lol
 

·
Registered
Joined
·
9,130 Posts
I checked all fuses that have to do with power windows and locks, and all seem to look fine, I took em all out and re-seeded and my back door window and lock wont work, any ideas?
Also disconnected the battery for 5 min. reconnected and still nothing.
 

·
Registered
Joined
·
53 Posts
anyone able to make a list of which fuses in the trunk fuse and passenger compartments are switched with the key/on or ignition?
 

·
Registered
Joined
·
193 Posts
on the same line, I need to wire up my dashcam and need to know if any of the fuses in the dash stay on with the ignition off. I remember reading somewhere that some of the fuses power down after 1/2 hour or so?
 

·
Registered
Joined
·
119 Posts
FYI it appears that the 2015 Focus ST has a fairly different fuse location layout than the one listed here. Below are pictures of the fuses and their locations according to my manual. I'm not sure if it differs between models, so please keep in mind I have an ST3. I will try to get some higher quality images, I just wanted to post this up here for anyone trying to use the original post for their 2015.

Also, for those who are looking for an ignition switched fuse, I ended up using the Heated Steering Wheel fuse, as that was one of the only ones I found that was off when the ignition was off.

 

·
Registered
Joined
·
4 Posts
Can someone please advise which one [fuse] to use to hardwire a Dashcam? Basically, I would like the Dashcam to switch on when I turn the car [Accessory] on. And off once the car is turned off. Just don't want the Dashcam to keep on recording after I've the left the car. I have noticed in my 2014 Ford Focus ST, the power stays on for the next 12 minutes after I've switched everything off. Thank you
 

·
Registered
Joined
·
439 Posts
Can someone please advise which one [fuse] to use to hardwire a Dashcam? Basically, I would like the Dashcam to switch on when I turn the car [Accessory] on. And off once the car is turned off. Just don't want the Dashcam to keep on recording after I've the left the car. I have noticed in my 2014 Ford Focus ST, the power stays on for the next 12 minutes after I've switched everything off. Thank you
There is a sticky 5 posts down from this one about hardwiring a dashcam... I know that I have seen fuse numbers mentioned in there, so it might be a good place to start.
 
1 - 12 of 12 Posts
Top