Search Results for ‘big turbo’

In setting up my BNR 2867 I have run into some confusion as to how to route the boost solenoids. I've watched these videos by Alan from Edge: - Title: HOW TO INSTALL FOCUS ST BOOST CONTROLLER - TItle: All You Need to Know About Boost Control and Wastegate In the videos he...

I'm looking for a BNR 2867 for sale. Edge Autosport is out of stock on both the 2867 and 3071. They said they'll probably be a month out on getting some more in stock, so I figured I'd try my luck on here. I'd ideally like a brand new kit (I would be willing to pay market price). A used one...

Hello Everyone, As some of you know i listed my car for sale and not long after i sent a rod through the oil pan. So i decided to keep the car and convert it to a track car only with as little weight as possible. In the future we do plan to swap some sort of AWD system into the car as well as...

A. Item for sale/trade (model, specs, etc.): 2016 Ford Focus St B. Condition: Used - Good C. Price/What you want to trade for: $17,000 D. Location of item: Phoenix Arizona E. Picture of item for sale or for trade MUST CONTAIN (within the same picture) a sheet of paper with the following on it...

I have seen a lot of posts relative to a 60-100 or 0-60, but none directly for a 60-130. Im curious to see what times have been made on a stock block and built. Im currently on a stock block (building motor on the side) with a sidewinder 3071r g2, 4 port ID1050s running E85 being tuned by Alan...

I'm back again and sorry if i am posting in the wrong thread. I attempted to search and didn't find anything similar. I was running a dual catch can from radium setup, although my sidewinder no longer allows for the ccv can placement. Because of this, the CCV hose is vented to atmosphere and...

Hello All, I am new to Forums so my apologies if i am posting this in the wrong section or if itt has been talked about already. I couldn't find anyone with a similar issue. I have a 16 FoST with a sidewinder setup GTX3071r G2 and radium engineering 4 port aux with ID1050 injectors. I am...

So looking for some help…few days ago me and a couple buddy’s installed the ATP Garret gtx2867 turbo and all the supporting mods(intake,intercooler, charge pipes,downpipe,exhaust,exhale kit in place of cold side charge pipe,and external wategate, and ofc a tune) anyway so we did the install...

This spring I am looking to go all in on a big turbo build. I'm torn between the GTX2867r v2 or the BNR ST67. Either will likely be with the .64 a/r. I understand I will need aux fueling and/or WMI, too. I've looked at both Stratified and Mountune, but am unsure of a four port or TB injection...

Hello all! I've a few questions for the community: I'm looking at going big turbo (I am still deciding which kit) to get to around 400hp for my daily ST. Will a WMI kit be enough to get to that number, or will I need port injection aux? If so, is one better than the other? I don't have...

For reference, I have a grx2867gen2 .67ar on stock fuel. I seem to have a boost leak that I can't find for the life of me. it was fine not too long ago, but now I can't seem to get over 25 psi, and off throttle vacuum rarely goes past -11.0 I have looked and checked every clamp, done a...

So I just put a gt3071r on my focus & everytime the car is wot it builds to about 19 psi & struggles for a bit then gets to 20 psi & sits at it until I let off the throttle. I sent my data logs to my tuner & he says the wgdc is spiratic so he said to check all the lines to the wastegate which I...

I have a 2013 ST with a gtx3071, Cobb intake, mishimoto FMIC, full roush exhaust that’s Cobb stage 2 tuned. Unfortunately this is a case of bought not built. Today I decided to use the AP to check for Engine codes and P0035 came up. The BOV (I’m not sure who makes it) seems to be functioning...

First time using this platform, don’t know if im on the right forum. So i made up my mind of going big turbo on my 2017 ST, GTX2867 specifically. What exactly do i need for this turbo to reliably hit around 350whp? Current setup: -CPE intercooler -Depo Racing 3”catless downpipe -AWE track...

My apologies if this was done incorrectly (it’s my first post), but I was curious if there was anyone looking to part with their gtx turbo? I’m in the market for one, but I would prefer to buy a used one in good condition to save some money and to also support a local member.

Hey guys, I recently had a bigger turbo installed, BNR 2867, and I've noticed a bit of smoking when starting the vehicle up. It will clear once the car warms up but it smokes really bad for the first couple minutes. It will also smoke a tiny bit also after driving it for a bit but that's a...

Whats up guys? My name is Nic and I am currently on deployment. I'll be coming home here in a few months and I have big plans for the ST when I do. I wanted to make a build thread so I can take you guys with me on my adventure since I'll be building from sub 300whp all the way to almost 450whp...

2014 Focus ST..cobb all kinds of everything..gtx2867r..343whp.2 separate protunes..my baby right here..just hit 45k with a full synthetic change at 44.5k. With no leaks...unless while driving and the oil didn't burn off..I would have smelled something or have noticed massive amounts smoke..In...