Sent from another galaxy.
Hey people, we have built a new HD Down Pipe bracket/mount and should be testing/installing it this week, as many of you have seen in another thread, since you have definitely shown lots of interest we went ahead and had one made.
Last edited by RDC; 05-27-2015 at 03:28 PM.
Hope to be installing in an ST.org members car for testing today or tomorrow
Any idea what durometer/material will be used?
I suppose this might not be completely determined until after testing...
I know they ordered something that can deal with the heat. I'll find out the durometer of the final part
2013 Performance Blue Focus ST3
Cobb Accessport with Mountune 93 Oct Custom Tune
Cobb Catback Exhaust
Cobb Rear Sway Bar
FSWerks Rear Stress Bar
MK1 Focus RS Shift Knob
Mountune Lower Sport Spoiler
Mountune Quick Shift Arm
18x8.5 et 38 Gun Blue Ray's Gram Light 57dr wheels (summer)
16x7 et 42 White Sparco Terra Wheels (winter)
Exactly something that i need!!!!,my first one ripped the pubber out after i put my downpipe in, and after i ordered another one and about a month later that was ripped too !!
2014 Ford Mustang GT/CS
-Corsa Sport GT500 Quad-Tipped Axle-Backs
-Airaid Race Intake
-Bama V2 93 Octane Race Tune
-Pypes Cat Deletes
-Boss 302 Coil Covers
Ok... we got the bracket/Hanger installed... fits great and will test for about a week. Told him to drive it hard and chk it periodically for any breaks or tears.
The right side hanger bar looks like it's off a little and looked same on OE bracket. But we will see how it holds up to hard driving.
It has also been suggested to slot both mount holes, so that's probably gonna happen also