Thanks for the advice, I'll do that tonight and provide an update once I'm done.
Just ordered mine! Crystal vision ultra works well but are anemic compared to most vehicles. Tried a set of OPT7 Fluxbeam and they glared badly. Hope these will do the trick!!
2018 HPR ST1 : Freektuned with Roush CBE, Green Filter, DD SL1 LED
Ordered my yellow SLF fogs and some trunk bulbs, thanks for the awesome sale!
Mountune RMM, intake
TB Performance traction bars, strut tower brace, rear end links
ST Suspensions rear sway bar
Michelin Pilot Sport 4S
Steeda jacking rails, mag drain plug
Boomba OCC, symposer delete, hood release
Shift Solutions 400g CS
JBR pedal spacer
Velossa Tech diffuser fins
Diode Dynamics SLF fogs, side mirror, trunk, vanity LEDs
Headlight Armor fog vinyls
Spec'D chrome smoked taillights
Mugen window visors
Boosted Designs dead pedal
Whiteline lateral locks (driver seat)
Blacksys CH-100B dual cam
I ordered SLF fogs for my '18 ST and '16 SE, and SL1 low beams for my SE. Can't wait. Hope the 6-8 week backorder goes quicker.
Got my SL1 bulbs in today. One of them has a loose wire inside the LED driver. Had to tape it in a certain direction to prevent it from cutting out. I emailed Diode for a replacement.
These lights do NOT glare and are way better than the stock bulbs. I don't get a nice straight cut off like they do in their site, but at least the output doesn't go above a certain point. It's like my car has RHD lights with the light pattern looking like a 1/4 pie. Point is towards the passenger side and the round edge is towards drivers side. It's weird but I can get used to this as this is way better than OPT7 crap led bulbs.
My stock halogens didn't have a nice beam pattern either. Must be the reflector design.
I give them a 8/10. Stock is 5/10. OPT7 is 2/10.
Pros : brighter and pretty with no glare
Cons : one defective bulb out of the box and a weird erratic beam pattern that may just be due to my reflector design.
Last edited by IcyFridge; 07-12-2018 at 08:25 PM.
All SL1 Headlight LED Bulb sizes are now IN STOCK! And don't forget to shoot us a PM for free USPS shipping on any U.S order!
I am ready to place an order for these and have PM'd the vendor but I don't know if I can do that and have the shipping cost removed later or if I am supposed to wait for them to send me a code to enter so it is removed when I place the order.