Ford Focus ST Forum banner

Aftermarket Seats installed

10K views 11 replies 7 participants last post by  Theillestjerm 
#1 ·
after a long time, ive finally gotten to installing my recaros sr7 Land vehicle Vehicle Car Luxury vehicle Family car
Land vehicle Vehicle Car Family car Subcompact car
 
See less See more
2
#7 ·
yesssss sr7s ftw!!! i used the sparco planted seat base, recaro sliders. I modified the seat base as they were sitting too low (i mean really really low).
basically my fabrication shop chopped off the mounting legs from the seat base, added 2 inch steel blocks on the 4 sides and welded them back (steel block in between the seat base and removed legs).

i hope you bought the low side bolsters sr7s. mines the medium height bolsters and its still a pain getting in and out of the car.
 
#11 ·
There's a guy on our Texas ST fb page that put corbeus in his ST and said all he did to get the light off was take it to the dealer where they did a "zero point inspection". No resistors or anything.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top